older leisure bay hot tub for 2 persons green

#Older leisure bay hot tub for 2 persons green series

If problem still remains, contact your dealer or service company. Press any button on the topside control to reset, or the message will automatically reset within 15 minutes. If water level is okay, check to see if the pumps are primed. Also, the Spa hot tub will shut down for 15 minutes.Ĭheck water level in hot tub. Possible low water levels, poor flow, or air bubbles are detected in the heater. Heating capability of the spa will not reset automatically you may press any button on the topside to reset the tub. (Displays on the fifth occurrence of “HL” error within a 24 hour cycle.) Heater is shut down, but other spa functions may continue to run normally.įollow steps required for “HL” message. If the error persists, contact your dealer or service company.Ĭontinuous low flow. If the water level is okay, check to see if the pumps are primed. This could be a flow problem.Ĭheck the water levels in tub. If the error continues, contact your dealer or service company.Ī difference between temperature and the sensors is detected. Also, if flashing by on its own, the spa will shut down. If alternating with spa temperature display, it may just be temporary. Sensors are out of balance or not working properly. (May appear temporarily in an overheat error and stop when the heater cools down.) If the problem does not go away, contact your dealer or service company. Also, the sensor that is plugged into the Sensor “B” jack is not operational. (This error may show temporarily in an overheat error and stop when the heater cools down.) The Spa is shut down or the sensor that is plugged into the Sensor “A” jack is not operational. The pump and blower will activate regardless of spa status during this error. “Ice” – This is a Potential freeze condition detected If the hot tub does not reset, turn off the power to the spa and call your dealer or service company. Once the spa cools down to 107☏, the tub should reset on its own. Remove the spa hot tub hard cover and allow water to cool off. Also, the sensors will detect that the hot tub water is 110☏ or greater.ĭO NOT ENTER THE WATER. “Overheat” – The leisure bay spas shuts down for this error. If your spa hot tub does not reset, shut the power off on the spa and call a dealer or service person. After the heater has cooled down, you must reset by pushing any of the topside buttons. Remove the spa hot tub cover and let the water cool down. The sensors have detected 118☏ or greater in the heater.ĭO NOT ENTER THE WATER.

After the pump and system has been operating approximately 2 minutes, you will see the temperature displayed. This happens when you initially start your hot tub. Contact your store for the unit to be serviced. The hot tub control panel is automatically disabled until return of power, but the system will function to reset the time of day of each time of power-up. GFCI breaker is still on, however, control panel displays blank. These are the error codes and display messages that a Leisure Bay Spa may display, along with what they mean and the action required:Ĭlick here for the Leisure_Bay_Spas_owners_Manual Message The Cover Guy custom makes replacement Leisure Bay Spas hot tub covers for all of the above.

#Older leisure bay hot tub for 2 persons green series

The Celebrity series has the following five models to choose from the Tonga, Santo, Hilo, Adirondack, and Galaxy. In the Elite series Leisure Bay Spas boasts 4 different models the Niagara, Hatteras, Cordova, and Harbor Cove. Leisure Bay Spas has been building hot tubs for over thirty years and has a range of hot tubs built on quality and new innovations in the hot tub market.